江森NAE35 NAE45网络控制引擎

江森 NAE35 NAE45网络控制引擎资料下载

/uploads/soft/130319/1-130319114P0.pdf

Application

Web-enabled, Ethernet-based, supervisory device that monitors and controls networks of field-level building automation devices, HVAC equipment, and lighting.

This document describes how to install NAE35 and NAE45 models, which are referred to collectively as NAE35/45 unless otherwise specified.

IMPORTANT:  In Metasys® system smoke 

control applications, use only the NAE35/NAE45 models that are UL Listed, UUKL 864 Listed, Smoke Control Equipment. See  Repair Information on page 10 for UUKL 864 Listed NAE35/NAE45 models. For Metasys system smoke control applications, you must refer to the Metasys System UL 864 UUKL Ninth Edition Smoke Control System Technical Bulletin (LIT-12011252) for detailed requirements and procedures for installing and operating UUKL

864 Listed Metasys system devices. Failure to meet the requirements or follow the procedures in the Metasys System UL 864 UUKL Ninth Edition Smoke Control System Technical Bulletin (LIT-12011252) can void the UUKL 864 listing for Smoke Control Equipment.

North American Emissions Compliance

United States

This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when this equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the 

user will be required to correct the interference at his/her own expense.

This Class (A) digital apparatus meets all the

requirements of the Canadian Interference-Causing

Equipment Regulations.

Cet appareil numérique de la Classe (A) respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.

Installation

Follow these guidelines when installing the NAE35/45:

• Transport the NAE35/45 in the original container to minimize vibration and shock damage to the NAE.

•     Verify that all the parts shipped with the NAE35/45.

• Do not drop the NAE35/45 or subject it to physical shock.

• Do not open the NAE35/45 housing (except the data protection battery compartment). The NAE35/45 has no user-serviceable parts inside.

Parts Included

•     one NAE35/45 with removable terminal plugs

• one data protection battery (installed and connected when the NAE35/45 is shipped)

•     one Installation Instructions sheet

Materials and Special Tools Needed

• three fasteners appropriate for the mounting surface (M4 screws [#8 screws])

• one 20 cm (8 in.) or longer piece of DIN rail and appropriate hardware for mounting the DIN rail

Mounting

Location Considerations

Follow these guidelines when mounting an NAE35/45:

•     Ensure that the mounting surface can support the

NAE35/45 and any user-supplied enclosure.

•     Mount the NAE35/45 in proper orientation

(Figure 1).